Моя статья — не полноценное описание продукта, а только небольшое уточнение хорошей публикации «FusionPBX, или снова-здорово, FreeSWITCH». Мне кажется в ней не очень хорошо раскрыта тема ACL в FusionPBX. Попробую заполнить этот пробел, исходя из собственного опыта работы с FreeSWITCH/FusionPBX. Читать дальше →
This advisory documents the impact of an internally found vulnerability in Arista EOS for security ACL bypass. The impact of this vulnerability is that the security ACL drop rule might be bypassed if a NAT ACL rule filter with permit action matches the packet flow. This could allow a host with an IP address in a range that matches the range allowed by a NAT ACL and a range denied by a Security ACL to be forwarded incorrectly as it should have been denied by the Security ACL. This can enable an ACL bypass.
A vulnerability in the dynamic access control list (ACL) feature of Cisco IOS XE Software running on Cisco Catalyst 4000 Series Switches could allow an unauthenticated, adjacent attacker to cause dynamic ACL assignment to fail and the port to fail open. This could allow the attacker to pass traffic to the default VLAN of the affected port. The vulnerability is due to an uncaught error condition that may occur during the reassignment of the auth-default-ACL dynamic ACL to a switch port after 802.1x…
When Eclipse Mosquitto version 1.0 to 1.5.5 (inclusive) is configured to use an ACL file, and that ACL file is empty, or contains only comments or blank lines, then Mosquitto will treat this as though no ACL file has been defined and use a default allow policy. The new behaviour is to have an empty ACL file mean that all access is denied, which is not a useful configuration but is not unexpected.